Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 245

:BUS<n>:BIT<m>
Command Syntax
:BUS<n>:BIT<m> <display>
<display> ::= {{1 | ON} | {0 | OFF}}
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
<m> ::= An integer, 0,..,15, is attached as a suffix to BIT
and defines the digital channel that is affected by the command.
The :BUS<n>:BIT<m> command includes or excludes the selected bit as
part of the definition for the selected bus. If the parameter is a 1 (ON),
the bit is included in the definition. If the parameter is a 0 (OFF), the bit
is excluded from the definition. Note: BIT0- 15 correspond to DIGital0- 15.
This command is only valid for the MSO models.
N O T E
Query Syntax
:BUS<n>:BIT<m>?
The :BUS<n>:BIT<m>? query returns the value indicating whether the
specified bit is included or excluded from the specified bus definition.
Return Format
<display><NL>
<display> ::= {0 | 1}
See Also •
•
•
•
•
•
Example Code
' Include digital channel 1 in bus 1:
myScope.WriteString ":BUS1:BIT1 ON"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to :BUS<n> Commands"
":BUS<n>:BITS" on page 246
":BUS<n>:CLEar" on page 248
":BUS<n>:DISPlay" on page 249
":BUS<n>:LABel" on page 250
":BUS<n>:MASK" on page 251
:BUS<n> Commands
on page 244
8
245