Wgen<W>:Period - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

34
:WGEN<w> Commands
:WGEN<w>:PERiod
Command Syntax
:WGEN<w>:PERiod <period>
<w> ::= 1 or 2 in NR1 format
<period> ::= period in seconds in NR3 format
For all waveforms except Noise and DC, the :WGEN<w>:PERiod command
specifies the period of the waveform.
You can also specify the period indirectly using the :WGEN<w>:FREQuency
command.
Query Syntax
:WGEN<w>:PERiod?
The :WGEN<w>:PERiod? query returns the currently set waveform
generator period.
Return Format
<period><NL>
<period> ::= period in seconds in NR3 format
See Also
•
•
•
1088
(see page 1208)
"Introduction to :WGEN<w> Commands"
":WGEN<w>:FUNCtion"
":WGEN<w>:FREQuency"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 1058
on page 1067
on page 1066