Ip Rip - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ip rip
Syntax
Release Information
Description
Mode
916
[ no ] ip rip
Command introduced before JunosE Release 7.1.0.
Configures RIP to run on the network specified by the network command. Uses the default
values: send version is RIP version 1, receive version is RIP version 1 and version 2,
authentication is not enabled. The no version deletes the RIP interface.
Interface Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
