Default-Metric - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
default-metric
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] default-metric metricValue [ interfaceType interfaceSpecifier ]
Command introduced before JunosE Release 7.1.0.
Configures RIP to use this metric on redistributed routes on all subsequently created
interfaces. The no version restores the default value, 0.
metricValue—Metric to apply to routes; in the range 1–16
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Address Family Configuration, Router Configuration
Chapter 5: D Commands
499
Advertisement
Table of Contents
