Mpls Atm Vpi Range - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
mpls atm vpi range
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
mpls atm vpi range minVPI maxVPI
no mpls atm vpi range
Command introduced before JunosE Release 7.1.0.
Specifies the range for virtual path identifiers that can be used in MPLS labels for an
MPLS major interface on an ATM AAL5 interface using the interface label space. Creates
the MPLS major interface if it does not yet exist. An error message is generated if you
issue the command for any other layer 2 interface, as they do not support the interface
label space. The no version deletes the range.
minVPI—Lowest virtual path identifier acceptable for a label, a value in the range 0–255
maxVPI—Highest virtual path identifier acceptable for a label, a value in the range
0–255
Interface Configuration
Chapter 13: M Commands
1329
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers