Match Route-Type - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

match route-type

Syntax
Release Information
Description
Options
Mode
1280
match route-type internal [ intra | inter ] [ level-1 | level-2 ]
[ external [ type-1 | type-2 ] ] [ level-1 | level-2 ]*
match route-type external [ type-1 | type-2 ] [ level-1 | level-2 ]
[ internal [ intra | inter ] ] [ level-1 | level-2 ]*
match route-type { level-1 | level-2 } [ internal [ intra | inter ] ]
[level-1 | level-2 ] [ external [ type-1 | type-2 ] ] [ level-1 | level-2 ]*
match route-type { level-1 | level-2 } [ external [ type-1 | type-2 ] ]
[ level-1 | level-2 ] [ internal [ intra | inter ] ] [ level-1 | level-2 ]*
no match route-type [ internal [ intra | inter ] | external [ type-1 | type-2 ] |
level-1 | level-2 ]
Command introduced before JunosE Release 7.1.0.
Matches routes of the specified type. The no version removes the match clause from a
route map unless you specify a value, in which case only that value is removed from the
match clause.
internal—Specifies internal routes
intra—OSPF intra-area routes
inter—OSPF interarea routes
external—Specifies external routes
type-1—OSPF type 1 external routes
type-2—OSPF type 2 external routes
level-1—Specifies IS-IS level 1 routes
level-2—Specifies IS-IS level 2 routes
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Policy List Configuration, Route Map Configuration
Copyright © 2010, Juniper Networks, Inc.