Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual page 1430

JunosE 11.2.x Command Reference Guide A to M
Mode
Related Topics
1386
NOTE: The relay-format keyword determines the pseudowire PW Type value that is
used in LDP protocol messages. For a complete list of pseudowire Type values, see
http://www.iana.org/assignments/pwe3-parameters.
If you do not specify the relay-format keyword in the mpls-relay or route interface
command, the pseudowire Type value is chosen based on the type of the interface. For
Ethernet interfaces, the pseudowire Type value is chosen as Ethernet (0x0005). For
VLAN interfaces, the pseudowire Type value is chosen as Ethernet Tagged Mode
(0x0004)
Interface Configuration, Subinterface Configuration
Configuring an MPLS Pseudowire with VCC Cell Relay, Configuring Ethernet/VLAN Layer
2 Services, Configuring Frame Relay Layer 2 Services, Configuring HDLC Layer 2 Services,
Configuring Local ATM Cross-Connects Between Ethernet/VLAN Interfaces, Configuring
Ethernet Raw Mode Encapsulation for Martini Layer 2 Transport, and Configuring S-VLAN
Tunnels for Layer 2 Services in the JunosE BGP and MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc.