Mpls Spf-Use-Any-Best-Path - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
mpls spf-use-any-best-path
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] mpls spf-use-any-best-path
Command introduced before JunosE Release 7.1.0.
Enables the SPF calculations to consider both the best IGP (IS-IS or OSPF) paths and
the MPLS tunnel to reach the tunnel endpoint. The no version restores the default value,
which is to always use the MPLS tunnel to reach the tunnel endpoint—the IGP best paths
are not considered.
Router Configuration
Chapter 13: M Commands
1407
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers