Ipv6 Nd Prefix-Advertisement - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ipv6 nd prefix-advertisement
Syntax
Release Information
Description
Options
Mode
1064
ipv6 nd prefix-advertisement ipv6Prefix/ipv6PrefixLength validLifetime preferredLifetime
[ onlink ] [ autoconfig ]
[ no ] ipv6 nd prefix-advertisement [ ipv6Prefix/ipv6PrefixLength ]
Command introduced before JunosE Release 7.1.0.
Profile Configuration mode added in JunosE Release 9.0.0.
Specifies which IPv6 prefixes the router includes in IPv6 router advertisements. In Profile
Configuration mode, you can configure a single prefix. The no version removes any prefixes
from the IPv6 routing advertisements.
ipv6Prefix—IPv6 network number to include in router advertisements
ipv6PrefixLength—Length of the IPv6 prefix; a decimal value that indicates how many
of the higher-order contiguous bits of the IPv6 address comprise the prefix (the network
portion of the IPv6 address). A slash (/) must precede this value.
NOTE: When used in an IPv6 profile, the ipv6PrefixLength must be set to a length of
64.
validLifetime—Amount of time in seconds that the router can advertise the specified
IPv6 prefix as valid; in the range 0–4294967295
preferredLifetime—Amount of time in seconds that the router can advertise the specified
IPv6 prefix as preferred; in the range 0–4294967295
onlink—Indicates that the specified prefix is assigned to the link
autoconfig—Indicates that local host links can use the specified prefix for IPv6
autoconfiguration
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
