Ipv6 Pim Spt-Threshold - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipv6 pim spt-threshold
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ipv6 pim spt-threshold { 0 | nonZeroInteger | infinity }
[ group-list ipv6AccessList ]
Command introduced before JunosE Release 7.1.0.
Specifies the network configuration that PIM sparse mode uses when a source starts
sending multicast messages. The no version restores the default value, 0.
0—Configures PIM sparse mode to switch to an SPT when a source begins to send
multicast messages
nonZeroInteger—Integer in the range 1–4294967294; prevents PIM sparse mode from
switching from a shared tree to an SPT
infinity—Prevents PIM sparse mode from switching from a shared tree to an SPT
ipv6AccessList—Name of the IPv6 access list that specifies the groups to which the
threshold applies
Global Configuration
Chapter 10: I Commands
1093
Advertisement
Table of Contents
