Log Severity - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

log severity

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
log severity { severityValue | off | severityNumber }
[ eventCategory [ instanceTree ] | eventCategory instanceTree | eventCategory ]
no log severity [ severityValue | off | severityNumber ] [ eventCategory
[ filters | instanceTree ] | eventCategory { filters | instanceTree } | eventCategory | * ]
Command introduced before JunosE Release 7.1.0.
Sets the severity level for systemwide logs (that is, when no individual event category is
specified) or for a specific event category. The no version returns severity changes to
their default settings or the systemwide setting.
NOTE: After you change the log severity level for an individual log event category, you
cannot use systemwide commands to subsequently change the severity level for that
category. To change individually altered log event categories using systemwide
commands, you must first change the log event back to its default setting.
severityValue and severityNumber—Minimum severity of the log messages displayed
for the selected category; described either by a descriptive term—severityValue—or by
a corresponding number—severityNumber—in the range 0–7. The lower the number,
the higher the priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant condition
info or 6—Informational message
debug or 7—Debug message
off—Disables systemwide log severity for all default level event categories when no
event category is specified or disables log severity for a specified event category
eventCategory—Log category; refer to the CLI online Help for available options
filters—Removes all log filters for the event category
instanceTree—Log-specific filter parameters; refer to the CLI online Help for available
options
*—Resets all log severities, systemwide and individual, to default settings
Chapter 12: L Commands
1239