L2Vpn Route-Target - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

l2vpn route-target

Syntax
Release Information
Description
Options
Mode
Related Topics
1196
[ no ] l2vpn l2VpnName route-target { import | export | both } extendedCommunity
Command introduced in JunosE Release 8.1.0.
Creates or adds to a list of VPWS L2VPN extended communities that the router uses to
determine which routes are imported by the specified VPWS L2VPN instance. The no
version removes a route target from the specified list.
l2VpnName—Name of the VPWS instance
import—Adds the route target to the import list for the specified VPWS instance; the
VPWS accepts only routes that have at least one route target that matches a route
target in the import list
export—Adds the route target to the export list for the specified VPWS instance; all
routes advertised from this VPWS are associated with the route targets in the export
list; at least one route target in the export list must match a route target in the import
list of a VPWS L2VPN receiving the route for the route to be accepted by the VPWS
L2VPN.
both—Adds the route target to both the import list and export list for the specified
VPWS instance; recommended setting for a VPWS instance
extendedCommunity—Two-part number of the format number1:number2 that identifies
an extended community of VPWS L2VPNs where:
number1—AS number or an IP address
number2—Unique integer; 32 bits if number1 is an AS number; 16 bits if number1 is an
IP address
Global Configuration
Configuring an L2VPN Instance in the JunosE BGP and MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc.