Ipv6 Policy-Parameter Reference-Rate - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

ipv6 policy-parameter reference-rate

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
In Interface Configuration mode:
ipv6 policy-parameter reference-rate parameterName [ increase ] value
no ipv6 policy-parameter reference-rate parameterName [ increase value ]
In Profile Configuration mode:
ipv6 policy-parameter reference-rate parameterName [ increase ] value
no ipv6 policy-parameter reference-rate parameterName
Command introduced in JunosE Release 8.1.0.
Creates an IPv6 policy parameter for a reference rate; creates a global parameter if it
does not exist. The no version removes the policy parameter and its contents; if used
with the increase keyword, decreases the value.
parameterName—Name of policy parameter up to 40 characters
increase—Increments the existing reference rate value
value—Value of the reference rate parameter, in the range 0–4292967295
Interface Configuration, Profile Configuration
Creating a Classifier Group for a Policy List
Chapter 10: I Commands
1099