Ipv6 Mld Ssm-Map Enable - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipv6 mld ssm-map enable
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ipv6 mld ssm-map enable
Command introduced before JunosE Release 7.1.0.
Enables SSM mapping on the router. SSM mapping statically assigns sources to MLDv1
groups. You must use SSM mapping for MLDv1 hosts to interoperate with PIM SSM. SSM
mapping allows the router to use a statically configured list to translate <*,G>
memberships to <S,G> memberships. The no version disables the SSM map.
NOTE: To operate correctly, the static source addresses configured with the ipv6 mld
ssm-map static command must fall within the configured PIM SSM range.
Privileged Exec, User Exec
Chapter 10: I Commands
1045
Advertisement
Table of Contents
