Isis Tag - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
isis tag
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] isis tag tagValue
Command introduced before JunosE Release 7.1.0.
Sets a route tag value for the IP addresses on an IS-IS interface before the route is
propagated to other routers in an IS-IS domain. To use the route tag, you must reference
it in a route map to set values and/or redistribute routes. The no version removes the
route tag from the interface.
tagValue—Number in the range 1–4294967295 that identifies the route tag assigned
to the IS-IS interface
Interface Configuration, Subinterface Configuration
Chapter 10: I Commands
1131
Advertisement
Table of Contents
