Member-Interface - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
member-interface
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] member-interface interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Adds a member interface, also known as a bundle member, to an MLPPP bundle, an
MLFR bundle, or an IEEE 802.3ad link aggregation group (LAG) bundle. The no version
removes the specified member interface from the bundle.
interfaceType—One of the following interface types listed in Interface Types and
Specifiers on page 5
serial (MLFR bundle or MLPPP bundle)
pos (MLFR bundle only)
fastEthernet (IEEE 802.3ad LAG bundle only)
gigabitEthernet (IEEE 802.3ad LAG bundle only)
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Interface Configuration, Subinterface Configuration
Chapter 13: M Commands
1301
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers