Hdlc Down-When-Looped - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
hdlc down-when-looped
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] hdlc down-when-looped
Command introduced before JunosE Release 7.1.0.
Enables loopback detection on a Cisco HDLC interface. Loopback detection is disabled
by default. The no version disables loopback detection.
Interface Configuration, Subinterface Configuration
Chapter 9: H Commands
677
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers