Isis Network Point-To-Point - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
isis network point-to-point
Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] isis network point-to-point
Command introduced before JunosE Release 7.1.0.
Specifies the IS-IS circuit type as point-to-point. Issuing this command tears down existing
adjacencies, originates or flushes LSPs, and establishes new adjacencies. The no version
restores the default, treating the circuit as a broadcast circuit.
Interface Configuration
Chapter 10: I Commands
1127
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?