Mpls Traffic-Eng Flood Thresholds - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mpls traffic-eng flood thresholds

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
mpls traffic-eng flood thresholds { up | down } percentage [ percentage ]*
no mpls traffic-eng flood thresholds { up | down }
Command introduced before JunosE Release 7.1.0.
Specifies thresholds for the flooding of the current reservable bandwidth throughout the
network. You can configure a set of thresholds for increases or decreases in bandwidth.
Flooding is triggered when the reservable bandwidth increases past any up threshold or
decreases past any down threshold. The no version restores the following default values:
For increases in bandwidth (up changes)—15, 30, 45, 60, 75, 80, 85, 90, 95, 97, 98, 99,
100
For decreases in bandwidth (down changes)—100, 99, 98, 97, 96, 95, 90, 85, 80, 75,
60, 45, 30, 15
up—Specifies that an increase in bandwidth past the threshold triggers flooding
down—Specifies that a decrease in bandwidth past the threshold triggers flooding
percentage—Percentage of reservable bandwidth, a value from 1 to 100 percent for
increasing bandwidth and from 0 to 99 percent for decreasing bandwidth
*—Indicates that the percentage can be repeated multiple times in a list in the command
line
Interface Configuration, Subinterface Configuration
Chapter 13: M Commands
1419