Default-Router - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
default-router
Syntax
Release Information
Description
Options
Mode
500
default-router ipAddressPrimary [ ipAddressSecondary ]
no default-router
Command introduced before JunosE Release 7.1.0.
Specifies the IP address of the router that the subscriber's computer will use for traffic
destined for locations beyond the local subnet. The default router must be on the same
subnet as the local server pool addresses configured with the network command. The
no version removes the association between the address pool and the router.
ipAddressPrimary—IP address of preferred router
ipAddressSecondary—IP address of secondary router
DHCP Local Pool Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?