Ethernet Oam Lfm High-Threshold - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ethernet oam lfm high-threshold

Syntax
Release Information
Description
Options
Mode
Related Topics
578
[ no ] ethernet oam lfm high-threshold { disable-interface | failover }
Command introduced in JunosE Release 11.1.0.
Configures a specific action to occur when a high threshold for an error is exceeded on
an Ethernet OAM interface. The no version removes the high-threshold action from the
interface of the local OAM client and causes no action to be performed when local errors
occur on the interface.
disable-interface—Sets the OAM functionality to unconditionally attempt to influence
the operational state of the interface to down. If the interface is a member link of a
LAG bundle and at least one other viable link (redundant member or another active/up
link) is present, OAM attempts to influence the operational state of the link to down.
Otherwise, no action is taken
failover—On GE-2 and GE-HDE line modules with GE-2 SFP I/O modules with physical
link redundancy, causes the link to transition from active to redundant
Interface Configuration
OAM Link Monitoring Feature
Configuring 802.3ah OAM Link-Fault Management
Example: Configuring 802.3ah OAM Link-Fault Management and Enabling Remote
Failure Monitoring on an Interface
Copyright © 2010, Juniper Networks, Inc.