Ipsec Clear Sa - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipsec clear sa
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ipsec clear sa { all [ state tunnelState ] | tunnel tunnelName } [ phase { 1 | 2 } ]
Command introduced before JunosE Release 7.1.0.
Refreshes ISAKMP/IKE or IPSec SAs. There is no no version.
all—Reinitializes all SAs
state—Reinitializes SAs on tunnels that are in a specific state
tunnelState—State of tunnel, up, down, not-present
tunnel—Specifies that an SA on a specific tunnel is to be reinitialized
tunnelName—Name of tunnel
phase—Specifies one of the following types of tunnel to be reinitialized:
1—ISAKMP/IKE tunnels
2—IPSec tunnels
Global Configuration
Chapter 10: I Commands
989
Advertisement
Table of Contents
