Ipv6 Prefix-List - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ipv6 prefix-list

Syntax
Release Information
Description
Options
Mode
1100
ipv6 prefix-list listName { description desc | { [ seq sequence ] { permit | deny } ipv6Prefix
[ ge geNumber ] [ le leNumber ] } }
no ipv6 prefix-list listName [ description | [ seq sequence ] [ { permit | deny } ipv6Prefix
[ ge geNumber ] [ le leNumber ] ] ]
Command introduced before JunosE Release 7.1.0.
Creates an IPv6 prefix list for route filtering; specifies a list entry—a permit or deny clause
for a network address. The no version removes the specified prefix list or the specified
list entry.
listName—Name of the IPv6 prefix list; a string of up to 32 characters
desc—Description of the prefix list
sequence—Number in the range 0–65535 that indicates the position the prefix list
entry has in the already existing list of entries for the prefix list; if you do not specify a
sequence, the command uses the value of the last sequence number + 5
permit—When specified, the router redistributes any prefix that matches the filtered
route based on the set actions
deny—When specified, the router drops any prefix that matches the filtered route
ipv6Prefix—Network route that you want to filter, in the format ipv6Address / length,
where
ipv6Address—Base IPv6 address of the network route that you want to filter (for
example, ::ffff:a:b:c:d)
length—Length of the network prefix; number of bits masking base address to produce
address to be matched
geNumber—Route being filtered matches if its prefix is within the range specified:
greater than or equal to geNumber and less than or equal to 32
leNumber—Route being filtered matches if its prefix is within the range specified: greater
than or equal to length and less than or equal to leNumber
Global Configuration
Copyright © 2010, Juniper Networks, Inc.