Mpls Topology-Driven-Lsp Ip-Interfaces - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

mpls topology-driven-lsp ip-interfaces

Syntax
Release Information
Description
Options
Mode
1412
[ no ] mpls topology-driven-lsp ip-interfaces [ egress | ingress ]
[ { access-list | prefix-list } listName ] [ host-only ]
no mpls topology-driven-lsp ip-interfaces [ egress | ingress ] [ host-only ]
[ policy-list ]
Command introduced before JunosE Release 7.1.0.
Specifies LSPs to be put into the IP routing table for forwarding plain IP traffic. The no
version removes the LSPs from the table.
NOTE: This command is deprecated and may be removed completely in a future release.
The function provided by this command has been replaced by the ldp ip-forwarding
command.
egress—Has no effect
ingress—Has no effect
access-list—Specifies that listName is an access list
prefix-list—Specifies that listName is a prefix list
listName—Name of access list or prefix list that specifies LSPs over which IP interfaces
are created
host-only— Specifies that only LSPs to host addresses are added to the IP routing
table
policy-list—Removes previously applied access lists or prefix lists
Global Configuration
Copyright © 2010, Juniper Networks, Inc.