Ipv6 Mld Query-Max-Response-Time - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipv6 mld query-max-response-time
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ipv6 mld query-max-response-time tenthsOfaSecond
no ipv6 mld query-max-response-time
Command introduced before JunosE Release 7.1.0.
Specifies the period in tenths of a second during which the host is expected to respond
to an MLD query. MLD version 1 includes this value in MLD query messages sent out on
the interface. The no version restores the default value, 100 tenths of a second (10
seconds).
tenthsOfaSecond—Time interval between receipt of an MLD query and the response;
in the range 1–254 tenths of a second.
Interface Configuration, Profile Configuration
Chapter 10: I Commands
1043
Advertisement
Table of Contents
