Instance-Interface-Type - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

instance-interface-type

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
instance-interface-type {instanceInterfaceType | set | superset }
no instance-interface-type { instanceInterfaceType | all }
Command introduced in JunosE Release 7.1.0.
lag keyword added in JunosE Release 8.1.0.
set and superset keywords added in JunosE Release 9.2.0.
Assigns an instance-interface type to a QoS parameter definition. Instance-interface
types indicate the interfaces for which QoS clients can assign QoS parameter instances.
You can specify up to eight instance-interface types for each parameter definition. The
no version removes the specified instance-interface type from the parameter definition.
instanceInterfaceType—One of the following instance-interface types: atm, atm-vc,
atm-vp, bridge, ethernet, fr-vc, ip, ip-tunnel, ipv6, lag, l2tp-session, l2tp-tunnel, lsp,
pppoe, serial, server-port, svlan, vlan
set—Specifies an interface set as an instance-interface type
superset—Specifies an interface superset as an instance-interface type
all—Removes all instance-interface types
QoS Parameter Definition
Configuring a Basic Parameter Definition for QoS Administrators
Creating a QoS Parameter on an Interface Superset or Interface Set
Chapter 10: I Commands
711