L2Vpn Sequencing - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

l2vpn sequencing

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
[ no | default ] l2vpn l2VpnName sequencing
Command introduced in JunosE Release 8.1.0.
Specifies that the local preference is to include nonzero sequence numbers with the
control word, enabling the remote PE to detect out-of-order packets. This command
has no effect if no control word is sent in the packets. The router always accepts zero
sequence numbers and checks the order of nonzero sequence numbers of MPLS packets
received from the remote PE. Any out of order packets are dropped, regardless of whether
sequencing is configured. The no version specifies that the sequencing number in the
control word is set to zero, instructing the remote PE router to not attempt to detect
out-of-order packets; has no effect if no control word is sent in the packets. The default
version accepts the preference determined by the interface stack on which the MPLS
shim interface is stacked.
l2VpnName—Name of the VPWS instance
Global Configuration
Configuring an L2VPN Instance in the JunosE BGP and MPLS Configuration Guide
Chapter 12: L Commands
1197