Ipsec Option Dpd - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ipsec option dpd
Syntax
Release Information
Description
Mode
1000
[ no ] ipsec option dpd
Command introduced before JunosE Release 7.1.0.
Enables IPSec dead peer detection (DPD) for the current virtual router. With DPD enabled,
the router detects when connectivity between the router and an IPSec peer has been
terminated. The router then sets the status for the tunnel and the upper layer interfaces
to down, which enables routing protocols to take alternate routes. Also, administrators
can then take corrective action. The no version restores the default DPD setting, disabled.
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers