Metric-Style Transition - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

metric-style transition

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] metric-style transition [ level-1 | level-2 | level-1-2 ]
Command introduced before JunosE Release 7.1.0.
Configures the router to generate and accept both old-style IS-IS TLVs with narrow
(six-bit) metric fields and new-style IS-IS TLVs with wider metric fields. If you issue this
command, the value configured with the isis metric command can range from 0–16777215.
The no version restores the default value, which is to generate and accept only old-style
TLVs with narrow (six-bit) metric fields.
level-1—Configuration applies only to level 1 routing
level-2—Configuration applies only to level 2 routing
level-1-2—Configuration applies to both level 1 and level 2 routing
Router Configuration
Chapter 13: M Commands
1307