Crc - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

Software for e series broadband services routers command reference a to m
Hide thumbs Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
Table of Contents

Advertisement

crc

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
crc { 16 | 32 | none }
no crc
Command introduced before JunosE Release 7.1.0.
Sets the size of the cyclic redundancy check. CRC is an error-checking technique that
uses a calculated numeric value to detect errors in transmitted data. 16 and 32 indicate
the number of check digits per frame that are used to calculate the FCS. Both the sender
and receiver must use the same setting. The default value is 16. The no version restores
the value to the default.
16—Specifies CRC-16, which transmits streams of 8-bit characters and generates 16-bit
check bits per frame
32—Specifies CRC-32, which transmits longer streams at faster rates and therefore
provides better ongoing error detection
none—Disables CRC checking
Interface Configuration
Chapter 4: C Commands
467

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.2

Table of Contents