Dsu Bandwidth - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
dsu bandwidth
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
dsu bandwidth bandwidthValue
no dsu bandwidth
Command introduced before JunosE Release 7.1.0.
Sets the speed for the fractional T3 lines. The no version clears the bandwidth. If you
issue this command, be sure to issue the dsu mode and scramblecommands. Similarly,
if you issue the no version, be sure to issue the no versions of the dsu mode and scramble
commands; otherwise, the interface may drop packets unexpectedly.
bandwidthValue—Value of the fractional bandwidth in the range 22–44210 Kbps. The
router offers a set of speeds in increments that depend on the DSU mode you specify.
The actual speed of the fractional T3 lines will be the value closest to the fractional
bandwidth you specify.
Controller Configuration
Chapter 5: D Commands
547
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers