Ip Prefix-Tree - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip prefix-tree

Syntax
Release Information
Description
Options
Mode
910
ip prefix-tree treeName { description desc | { permit | deny } ipPrefix }
no ip prefix-tree treeName [ description | { permit | deny } ipPrefix ]
Command introduced before JunosE Release 7.1.0.
Creates a prefix tree for best-match route filtering; specifies a tree entry—a deny or permit
clause for a network address. The no version removes the specified prefix tree or the
specified tree entry.
treeName—Name of the prefix list; a string of up to 32 characters
desc—Description of the prefix list
deny—If the prefix of the route being filtered matches the specified prefix and deny is
specified, the route is not redistributed
permit—If the prefix of the route being filtered matches the specified prefix and permit
is specified, the route is redistributed as controlled by the set actions
ipPrefix—Network route to be filtered, in the format network / length, where
network—Base address of the network route to be filtered; for example, 192.168.32.0
or 10.10.0.0
length—Length of the network prefix; number of bits masking base address to produce
address to be matched
Router Configuration
Copyright © 2010, Juniper Networks, Inc.