Line - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

line

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
line { console lineNumber | vty lineRangeStart [ lineRangeEnd ] }
no line vty lineNumber
Command introduced before JunosE Release 7.1.0.
Opens virtual terminal lines or the console line and allows you to configure the lines. By
default five vty lines (0–4) are open. The no version removes a vty line or a range of lines
from your configuration; users will not be able to run Telnet, SSH, or FTP to lines that you
remove. When you remove a vty line, the router removes all lines above that line. For
example, no line vty 6 causes the router to remove lines 6 through 29. You cannot remove
lines 0 through 4.
NOTE: Once lines are open, login is enabled by default. Before users can access the
lines, you must configure a password, disable login using the no login command, or
configure AAA authentication on the line.
console—Specifies the console line
vty—Specifies vty lines
lineNumber—Number of a single line; 0 for the console line
lineRangeStart—Start of the vty line range; a number from 0–29
lineRangeEnd—End of the vty line range; a number from 0–29
Global Configuration
Chapter 12: L Commands
1215