Mask-Val - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mask-val

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
[ no ] mask-val value
Command introduced before JunosE Release 7.1.0.
Color Mark Profile Configuration mode added in JunosE Release 7.2.0.
Sets the mask value. For rate limits, use this command with the committed-action,
conformed-action, and exceeded-action commands. For color-mark profiles, use the
mask-val command in Color Mark Profile Configuration mode. The no version restores
the default value, 255.
value—Mask value in the range 0–255. Use the following mask values to set the
appropriate bits in the ToS field of the IP packet header:
IP Precedence—0xE0 (three most significant bits)
DS Field—0xFC (six significant bits)
TOS (IP) or Traffic Class field (IPv6)—0xFF (default)
Color Mark Profile Configuration, Rate Limit Profile Configuration
Creating a Two-Rate Rate-Limit Profile
Setting the Mask Value for MPLS Rate-Limit Profiles
Setting the Mask Value for IP and IPv6 Rate-Limit Profiles
Chapter 13: M Commands
1265