Mirror - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mirror

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
To mirror a specified trigger type:
mirror triggerType [hex] triggerValue { ip | ipv6 | l2tp } secure-policy-list policyName
no mirror triggerType [hex] triggerValue { ip | ipv6 | l2tp }
To mirror the agent-circuit-id or agent-remote-id trigger types, when the hex variant is
used:
mirror triggerType hex triggerValue { ip | ipv6 | l2tp } secure-policy-list policyName
no mirror triggerType hex triggerValue { ip | ipv6 | l2tp }
To mirror the dhcp-option-82 trigger type:
mirror dhcp-option-82 agent-circuit-id triggerValue1 agent-remote-id triggerValue2 ip
secure-policy-list policyName
no mirror dhcp-option-82 agent-circuit-id triggerValue1 agent-remote-id triggerValue2
ip
To mirror the dhcp-option-82 trigger type, when the hex variant is used:
mirror dhcp-option-82 hex triggerValue ip secure-policy-list policyName
no mirror dhcp-option-82 hex triggerValue ip
Command introduced before JunosE Release 7.1.0.
nas-port-id keyword added in JunosE Release 7.1.0.
IPv6 support added in JunosE Release 10.1.0.
hex keyword added in JunosE Release 11.1.0.
Enables packet mirroring based on the specified trigger and specifies the secure policy
to attach to the subscriber's interface. The no version disables packet mirroring for the
subscriber and removes the trigger configuration.
NOTE: The hex variant is applicable only for agent-circuit-id, agent-remote-id, and
dhcp-option-82 trigger types. If the hex variant is used then the triggerValue must be a
hexadecimal number.
triggerType—One of the following RADIUS attributes
acct-session-id—Acct-Session-Id, RADIUS attribute [44]
agent-circuit-id—Agent Circuit ID, RADIUS attribute [26–1], Vendor ID 3561
agent-remote-id—Agent Remote ID, RADIUS attribute [26–2], Vendor ID 3561
Chapter 13: M Commands
1311