Ipsec Transport Profile - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ipsec transport profile

Syntax
Release Information
Description
Options
Mode
1004
[ no ] ipsec transport profile { profileName [ [ virtual-router vrName ]
ip address ipAddress ] | [ virtual-router vrName ] ip address ipAddress }
no ipsec transport profile { profileName
| [ virtual-router vrName ] ip address ipAddress }
Command introduced before JunosE Release 7.1.0.
Creates or configures a transport profile for IPSec and accesses the IPSec Transport
Profile Configuration mode. The no version deletes the transport profile.
profileName—Name of the transport profile
vrName—Name of the VR on which you want to create the profile. If you do not specify
a virtual router, the current virtual router context is used
ipAddress—Remote endpoint for the IPSec transport connection. You can enter a single
IP address or the wildcard address of 0.0.0.0. If you use the wildcard address, the
profile accepts any remote client connection, which is a typical scenario for secure
remote access.
Global Configuration
Copyright © 2010, Juniper Networks, Inc.