Ipv6 Local Pool - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ipv6 local pool
Syntax
Release Information
Description
Options
Mode
1028
ipv6 local pool poolName
no ipv6 local pool poolName [ force ]
Command introduced in JunosE Release 10.1.0.
Accesses IPv6 Local Pool Configuration mode. Specifies the IPv6 local address pool
from which prefixes are allocated to the requesting router in networks that use DHCPv6.
The no version removes the IPv6 local pool.
poolName—Name of the IPv6 local address pool to be used to delegate prefixes to
the requesting routers or DHCPv6 clients; string of up to 16 alphanumeric characters
force—Forcibly deletes an IPv6 local address pool from which prefixes have been
allocated. When a pool from which prefixes have been assigned to DHCPv6 clients is
deleted, the corresponding DHCPv6 bindings are also deleted.
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
