Mpls Ldp Vpls Vpls-Id - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mpls ldp vpls vpls-id

Syntax
Release Information
Description
Options
Mode
Related Topics
Copyright © 2010, Juniper Networks, Inc.
mpls ldp vpls vplsName vpls-id vplsId
no mpls ldp vpls vplsName vpls-id
Command introduced in JunosE Release 8.2.0.
Configures the globally unique VPLS identifier of a VPLS instance that uses LDP as the
signaling protocol. All VEs that participate in the same VPLS domain must use the same
VPLS identifier. The VPLS identifier configured for a VPLS instance must not be the same
as the PWid for Martini configurations for Ethernet layer 2 services over MPLS. The no
version deletes the VPLS identifier from the VPLS instance.
The mpls ldp vpls vpls-id command is not valid for a VPLS instance that uses BGP as
the signaling protocol. To configure a VPLS instance with BGP signaling, use the bridge
vpls rd, bridge vpls route-target, bridge vpls site-name site-id, and bridge vpls site-range
commands.
vplsName—Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
vplsId—VPLS identifier for the VPLS instance, in the range 1–4294967295
Global Configuration
Configuring LDP Signaling for VPLS in the JunosE BGP and MPLS Configuration Guide
Chapter 13: M Commands
1371