Max-Sessions - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

max-sessions

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
For RADIUS:
max-sessions sessionLimit
no max-sessions
For AAA domain map and tunnel group tunnels:
max-sessions maxSessionsPerTunnel
{ no | default } max-sessions
For L2TP:
max-sessions maxSessionsPerProfile
{ no | default } max-sessions
Command introduced before JunosE Release 7.1.0.
For RADIUS, specifies the number of outstanding requests to a server. The no version
reverts to the default value.
For AAA domain map, and tunnel group tunnels , sets the maximum sessions per tunnel.
The no version disables the feature. The default version sets the value to zero.
For L2TP, sets the maximum sessions allowed for destination and host profiles by the
LNS. The no and default versions disable the feature.
sessionLimit—Maximum number of outstanding requests to a specific server in the
range from 10 through to the maximum value; default value is 255
For information about the number of concurrent RADIUS requests that the router
supports for authentication and accounting servers, see JunosE Release Notes, Appendix
A, System Maximums.
maxSessionsPerTunnel—Maximum number of sessions that can be configured on a
tunnel in the range 0–4294967295; default value is zero
maxSessionsPerProfile—Maximum number of sessions that can be established at the
LNS for a destination or host profile; in the range from 1 through to a maximum of the
chassis-wide limit; default value is the chassis-wide limit
For information about the maximum number of L2TP sessions supported per chassis,
see JunosE Release Notes, Appendix A, System Maximums.
Domain Map Tunnel Configuration, L2TP Destination Profile Configuration, L2TP
Destination Profile Host Configuration, RADIUS Configuration, Tunnel Group Tunnel
Configuration
Chapter 13: M Commands
1291