L2Tp Drain Destination - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

l2tp drain destination

Syntax
Release Information
Description
Options
Mode
1166
[ no ] l2tp drain destination { destinationName
| [ virtual-router vrName ] ip ipAddress }
Command introduced before JunosE Release 7.1.0.
Prevents the creation of new tunnels and sessions at a destination. This command works
in conjunction with the l2tp shutdown destination command. Both commands affect
the status of the administrative state of L2TP for the destination; the l2tp drain
destination command sets the administrative state to drain. The no version allows the
creation of new tunnels and sessions at a destination.
destinationName—Name the router assigns to the LNS
vrName—Name of the virtual router on which the destination exists
ipAddress—IP address of the LNS
Global Configuration
Copyright © 2010, Juniper Networks, Inc.