Interface Tunnel - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
interface tunnel
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] interface tunnel interfaceSpecifier [ transport-virtual-router vrName ]
[ ipsec-transport ]
Command introduced before JunosE Release 7.1.0.
Creates a tunnel interface for use by DVMRP, GRE, IPSec, or MPLS. You can specify that
the tunnel be established in the routing space of a virtual router other than the current
VR. If you specify another VR, all tunnel commands apply to the tunnel in that VR. If you
do not specify another VR, tunnel commands apply to the current VR. For DVMRP and
GRE tunnels, you can specify that the tunnel be protected with IPSec in transport mode.
The no version removes the tunnel interface.
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
vrName—Name of virtual router (other than the current VR) in which the tunnel will be
established
ipsec-transport—Indicates that the tunnel is protected with IPSec in transport mode;
used for GRE or DVMRP tunnels only
Global Configuration
Chapter 10: I Commands
727
Advertisement
Table of Contents
