Mpls Ldp Autoconfig - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

mpls ldp autoconfig

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
From Interface Configuration mode and Subinterface Configuration mode:
[ no ] mpls ldp { isis | ospf } autoconfig
From Router Configuration mode for IS-IS:
mpls ldp autoconfig [ level-1 | level-2 | level-1-2 ]
no mpls ldp autoconfig
From Router Configuration mode for OSPF:
mpls ldp autoconfig [ areaId | areaIdInt ]
no mpls ldp autoconfig
Command introduced in JunosE Release 8.1.0.
In Interface Configuration mode, creates LDP on the current interface. The no version
removes LDP from the interface.
In Router Configuration mode, creates LDP on all interfaces in the IS-IS or OSPF router,
on interfaces in the specified level (IS-IS), or on interfaces in the specified area (OSPF).
The no version removes the LDP configuration for all qualifying interfaces.
level-1—Enables LDP on all IS-IS level 1 interfaces
level-1-2—Enables LDP on all IS-IS level 1-2 interfaces
level-2—Enables LDP on all IS-IS level-2–only interfaces
areaId—OSPF area ID in IP address format
areaIdInt—OSPF area ID as a decimal value in the range 0–4294967295
Interface Configuration, Router Configuration, Subinterface Configuration
Chapter 13: M Commands
1343