Ipsec Key Pubkey-Chain Rsa - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ipsec key pubkey-chain rsa

Syntax
Release Information
Description
Options
Mode
996
[ no ] ipsec key pubkey-chain rsa { address ipAddress | name identityString }
Command introduced in JunosE Release 7.1.0.
Enables you to configure the public key for a remote peer with which you want to establish
IKE SAs. This command accesses IPSec Peer Public Key Configuration mode, from which
you can enter the peer public key data without the need for a digital certificate. Public
keys are used during the tunnel establishment phase when the ISAKMP/IKE policy
specifies RSA digital signature authentication. The no version removes the peer public
key from the router.
ipAddress—IP address of the peer for which the public key can be used, in 32-bit dotted
decimal format (for example, 192.168.32.2)
identityString—Identity of the remote peer for which the public key can be used, either
in fully qualified domain name (FQDN) format (for example,
group003.customer535.isp.net) or in FQDN format preceded by an optional user@
specification (for example, tsmith@group003.customer535.isp.net); maximum of 80
characters
Global Configuration
Copyright © 2010, Juniper Networks, Inc.