Mpls Signaling-Interface - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
mpls signaling-interface
Syntax
Release Information
Description
Options
Mode
1406
mpls signaling-interface interfaceType interfaceSpecifier
no mpls signaling-interface
Command introduced in JunosE Release 7.1.0.
Specifies a particular layer 2 interface as the signaling interface for an MPLS major
interface that is stacked on an ATM AAL5 interface. MPLS uses the IPv4 or IPv6 interface
stacked on the specified interface for signaling. The no version restores the default
behavior, wherein MPLS nondeterministically selects a layer 2 interface as the signaling
interface.
NOTE: You can configure this command only for interfaces that use the interface label
space. For interfaces that use the platform label space, the signaling interface is always
next to the MPLS major interface, that is, stacked on the same lower interface and is
not configurable.
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers