JunosE 11.2.x Command Reference Guide A to M
load-interval
Syntax
Release Information
Description
Options
Mode
1222
load-interval timeInterval
no load-interval
Command introduced before JunosE Release 7.1.0.
Sets the time interval at which the router calculates bit rates and packet rates for an
interface. The no version restores the default value, 300 seconds. This command is not
available for the Ethernet interface on the SRP module.
timeInterval—Multiple of 30 seconds; in the range 30–300
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.