Ipv6 Pim Dr-Priority - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ipv6 pim dr-priority
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ipv6 pim dr-priority priority
no ipv6 pim dr-priority
Command introduced in JunosE Release 10.0.0.
Assigns a priority for the interface to be selected as the designated router. An interface
with a higher priority value is preferred as a designated router over an interface with a
lower priority value. In Interface Configuration mode, the no version restores the value
that is specified in Router Configuration mode. If the designated router priority is not
specified in Router Configuration mode, then the default value of one is restored.
NOTE: You cannot configure the designated router priority on PIM dense mode
interfaces.
priority—Value in the range 1–254; default value is 1.
Interface Configuration, Router Configuration
Chapter 10: I Commands
1085
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers