Ip Nat Inside Source List - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip nat inside source list

Syntax
Release Information
Description
Options
Mode
866
ip nat inside source list accessListName pool poolName [ overload ]
no ip nat inside source list accessListName
Command introduced before JunosE Release 7.1.0.
Creates dynamic translation rules that are applied to a source address when routing a
packet from the inside network to the outside network, and for translating the destination
address when a packet returns from the outside network to the inside network. The no
version removes the dynamic translation rule.
NOTE: This command does not remove any dynamic translations from the translation
table.
accessListName—Name of the access list that you want to use for this dynamic
translation
poolName—Name of the NAT IP address pool that contains addresses you want to
use when translating matched access list addresses
overload—Specifies that the translation process create extended translation table
entries (IP address, protocol, and port values)
Global Configuration
Copyright © 2010, Juniper Networks, Inc.