Ip Ospf Transmit-Delay - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
ip ospf transmit-delay
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ip ospf transmit-delay transmDelay
no ip ospf transmit-delay
Command introduced before JunosE Release 7.1.0.
Sets the estimated time it takes to transmit a link-state update packet on the interface.
The no version restores the default value.
transmDelay—Link-state transmit delay, a number in the range 0–3600 seconds;
default value is 1 second
Interface Configuration, Subinterface Configuration
Chapter 10: I Commands
887
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers