Ipv6 Policy - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

ipv6 policy

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
ipv6 policy { input | output } policyName
[ statistics { enabled [ baseline { enabled | disabled } ] [ preserve | merge ] |
disabled [ merge ] } | merge ]
no ipv6 policy { input | output | secondary-input } [ policyName ]
For policy lists in Profile Configuration mode:
ipv6 policy { input | output } policyName
[ statistics { enabled | disabled } ] [ merge ]
no ipv6 policy { input | output | secondary-input } [ policyName ]
Command introduced before JunosE Release 7.1.0.
merge keyword added in JunosE Release 7.2.0.
Profile Configuration mode added in JunosE Release 7.2.0.
In Interface Configuration mode, assigns a policy list to the ingress or egress of an interface.
If you enter the ipv6 policy command and the policy list does not exist, the router creates
a policy list with no rules, the default. When a policy list does not have rules, the router
inserts a default filter rule. Attaching this policy list to an interface filters all packets on
that interface. You must specify the input or output keyword to assign the policy list to
the ingress or egress of the interface.
In Profile Configuration mode, assigns the policy list to a profile, which then assigns the
policy to an interface.
The no version removes the association between a policy list and an interface. In Profile
Configuration mode, the no version removes policy reference from the profile.
input—Applies policy to data arriving at this interface before a route lookup
output—Applies policy to data leaving this interface
secondary-input—Applies policy to data that arrives at this interface after a route
lookup
policyName—Name of the policy; a maximum of 40 characters
statistics—Enables or disables collection of policy routing statistics
enabled—Enable collection of policy routing statistics
baseline enabled—Enables baselining of policy routing statistics (Interface
Configuration mode only)
baseline disabled—Disables baselining of policy routing statistics (Interface
Configuration mode only)
Chapter 10: I Commands
1095