Metric - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
metric
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
metric globalDefault [ level-1 | level-2 ]
no metric [ level-1 | level-2 ]
Command introduced in JunosE Release 9.0.0.
Sets the metric to the same value for all active IS-IS IPv4 and IPv6 interfaces at the
specified level. If you do not specify level 1 routers or level 2 routers, then the metric is
applied to both level 1 and level 2 routers. The no version restores the individual default
value, 10.
globalDefault—Metric used for all IS-IS interfaces; a number in the range 1–16777215;
overridden by the isis metric command
level-1—Configuration applies only to level 1 routing
level-2—Configuration applies only to level 2 routing
Router Configuration
Chapter 13: M Commands
1305
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers